EN ISO 1797-2-1995 牙科旋转器具.柄.第2部分:塑料柄

上一篇: EN ISO 8316-1995 封闭管道内液体流量的测量.容积测量箱的液体收集法(ISO8316:1987);德文版本ENISO8316:1995
下一篇: DIN EN 29367-2-1995 滚装船舶海运用公路车辆的捆绑和固定装置.一般要求.第2部分:半挂车(ISO9367-2:1994);德文版本EN29367-2:1994

【英文标准名称】:Geotextilesandgeotextile-relatedproducts.Screeningtestmethodfordeterminingtheresistancetohydrolysis
【原文标准名称】:地功织物和地功织物相关产品.测定对水解作用抗性的筛除法
【标准号】:BSDDENV12447-1998
【标准状态】:作废
【国别】:
【发布日期】:
【实施或试行日期】:
【发布单位】:英国标准学会(GB-BSI)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:
【英文主题词】:
【摘要】:
【中国标准分类号】:
【国际标准分类号】:
【页数】:
【正文语种】:


Product Code:SAE AS4052
Title:Gland Design: Scraper, Landing Gear, Installation
Issuing Committee:A-5b Gears, Struts And Couplings Committee
Scope:This SAE Aerospace Standard (AS) covers an alternate gland design for the installation of scraper/ wiper rings in the lower end of landing gear shock struts for the purpose of contaminant exclusion.The defined scraper gland covered by this document, as shown in Table 1, is a variant of AS4716, the accepted gland standard for MS28775, O-ring packing seals. Piston rod diameters, gland internal diameters, groove sidewall angles and the surface finish are all defined by AS4716, but the gland outer retaining wall diameter is changed. The traditional scraper design installed into the glands detailed in Table 1 typically utilize components made from urethane or nitrile materials. These scraper designs, while still acceptable, must be reviewed in consideration to deicing, cleaners and disinfectant fluids applied to or in contact with the landing gear, as the materials of construction for the installed scrapers may not be compatible to these fluids. Exposure of the scraper to incompatible fluids is likely to reduce the performance of the scraper.In addition, an alternative scraper gland is also covered by this document and shown in Table 2. It is also a variant of AS4716, however this gland has a reduced atmospheric gland lip and profiled lead in geometry to allow for a PTFE jacket metal spring energized scraper to be installed. The advantages of the PTFE jacket metal spring energized scraper design is that the materials of construction are chemically inert, greatly reducing the possibility of negative performance due to incompatibility with deicers, cleaners and disinfectant fluids. AS4088 is similar to the hardware design in Table 1 of this document, which was developed by SAE A-6 for flight control and general-purpose cylinders. It differs from this document primarily by the clearance between the rod (piston) and outer gland wall.